Two different ways to heat the same house
A furnace burns gas to heat air directly and pushes it through ductwork. A heat pump moves heat instead of generating it directly, pulling warmth from outside air even when it's cold out, and running the same process in reverse to cool the house in summer. Both can heat a Toronto house properly. The right one, or the right combination, depends on the house, the ductwork, and what's already there.
Cold-climate heat pumps
Standard heat pumps lose heating output as the outdoor temperature drops, and can fall off noticeably on a cold night. Cold-climate models are built to keep producing heat well below freezing, which is the rating that matters for a Toronto winter more than the summer cooling numbers. We look at a model's rated output at low outdoor temperatures against your house's heat loss before recommending one as a primary heat source.
Hybrid setups with a gas furnace as backup
A dual-fuel, or hybrid, setup keeps your gas furnace in place and adds a heat pump that carries most of the heating season, with the furnace taking over automatically in the coldest stretches. It's a common path where the furnace is in good shape, since it lowers how much of a Toronto winter the heat pump alone has to carry, and it keeps a gas backup in place for the nights a standard, or even a cold-climate, model would otherwise struggle with. We set the controls so the two hand off to each other properly rather than fighting for the load.
Ducted or ductless
A ducted heat pump connects into existing forced-air ductwork, working alongside or replacing a furnace and central AC. A ductless heat pump uses one or more wall or ceiling heads connected by a refrigerant line instead, which fits houses with no ductwork at all, like older houses that heat with a boiler and radiators. A ducted heat pump paired with the existing furnace in a hybrid setup uses the same ducts for both, so the ductwork itself usually doesn't need to change, only the outdoor equipment and the controls tying the two together. See ductless mini-splits for how the ductless setup works room by room.
Electrical capacity
A heat pump needs its own dedicated circuit, and adding one is straightforward in some houses and not in others. Older Toronto homes sometimes have a panel that's already close to full, or a service that's small for everything the house already runs. We check the panel before recommending a heat pump and tell you if it needs an electrician's attention first, which is a real step in the decision, not a footnote.
The dedicated circuit itself is only part of it. Where the panel's spare capacity, or lack of it, sits relative to the rest of the house's electrical load is what we're actually checking, not just whether there's an empty breaker slot.
A furnace's gas burner and a heat pump's compressor and defrost cycle have different maintenance needs and sound different in daily use. A heat pump's outdoor unit runs through more of the year than an AC-only condenser, including defrost cycles in winter that can sound like the unit working harder than usual; that's normal operation, not a fault. We walk through what to expect for each so it doesn't read as a problem the first winter.
What a Toronto winter means for the choice
Toronto sees stretches well below minus 15 °C most winters, and that's the range where the gap between a standard heat pump and a cold-climate model, or between heat-pump-only and a hybrid setup, shows up. A furnace alone doesn't have this problem, since it burns gas at roughly the same rate regardless of outdoor temperature. The trade-off with a heat pump is real, and it's also manageable, which is why sizing for the coldest stretch of the year, not an average winter day, is the starting point for any heat pump recommendation we make.
That's also why we size a hybrid setup's switchover point around your specific house's heat loss rather than a single rule of thumb that ignores how exposed or how well insulated it is. Whichever direction you go, the ductwork's condition, or the lack of it in a radiator house, still sets the limits on what any forced-air or ducted system can deliver. A heat pump doesn't fix undersized returns or leaky supply runs any more than a new furnace would, so if airflow problems already exist, they're worth addressing as part of the same job rather than assuming new equipment solves them on its own.
Rebates
Ontario's Home Renovation Savings program currently covers qualifying heat pumps. Amounts change, and the homeowner claims it through a contractor registered with the program. Ask and we will tell you what applies to your house.
Deciding between the two
If your furnace still has good life left and the ductwork suits it, a furnace replacement alone may be the simpler answer for now, with a heat pump to consider later. If the furnace is due at the same time, a hybrid setup lets you add a heat pump for most of the season while keeping the furnace for backup. We look at the age and condition of what you already have, your ductwork, and your panel, and tell you which setup we'd recommend. Our guide on furnace replacement cost in Toronto covers the furnace side of that comparison, and heat pump installation has more on sizing. Request a visit to get a recommendation for your house.