Why there's no price list on this page
A price list for AC repair would have to pretend that every failed part, every system, and every house is the same, and none of them are. A repair bill is the part, the refrigerant if any is involved, and the labour to diagnose, reach, and replace what failed. Each of those moves independently.
What we can do is show you what moves the number, so when you have a written quote in hand, from us or anyone else, you can see what you're paying for. We diagnose first and quote in writing before any repair starts. If your system has already stopped cooling and you want to rule out the simple stuff before calling, start with our guide on what to check when the AC isn't cooling.
The part that failed does most of the deciding
Most AC repairs come down to a short list of parts, and they sit at very different points on the scale.
At the lighter end are the electrical components: the capacitor that gives the compressor and fan motors their starting push, and the contactor that switches the outdoor unit on and off. Both wear out with normal use, both are quick to test, and both are among the most common reasons an AC hums but won't start. A clogged condensate drain line or a failed condensate pump sits in the same range.
The middle of the scale is motors and boards: a condenser fan motor that has seized, a blower motor inside on the furnace side, or a control board fault. More labour, more expensive parts, still well short of a replacement conversation on a reasonably young system.
At the heavy end sit the compressor and the coils. The compressor is the heart of the system and the single most expensive part in it. The evaporator coil above the furnace and the condenser coil outside are close behind, because replacing either one is hours of refrigerant-side work, not a swap. When one of these fails on an older unit, the honest conversation is usually repair versus replace, not which part to order.
Refrigerant can change the math on its own
If the diagnosis involves refrigerant, two questions decide how the bill moves: what refrigerant the system runs on, and whether anyone has found the leak.
Air conditioners from before about 2010 often run on R-22, which is no longer made or imported in Canada. What remains is reclaimed supply, and it is priced accordingly. A leak on an R-22 system is usually the point where replacement becomes the sensible option, because the same leak on the same coil will cost far less to deal with on a current system running R-410A or a newer refrigerant.
The second question matters on any system: a unit that needs refrigerant has a leak, because refrigerant circulates in a sealed loop and doesn't get used up. Topping up without finding the leak buys one season at best, and the money spent on that top-up is gone when the real repair happens. We find the leak first, then quote the actual fix.
Age, parts availability, and the repair-worthiness line
The same repair is not worth the same amount on every unit. A condenser fan motor on a seven-year-old system is an easy yes. The same motor on a unit past fifteen, with a compressor of the same age behind it, deserves a harder look, because the next failure may be the expensive one.
Age also shows up as parts availability. Boards and motors for discontinued models can be slow to source or gone entirely, and a repair that waits on a rare part is a repair that costs more and takes longer. When we quote a repair on an older unit, we tell you what we think of the unit behind the part, in writing, so you're deciding with the whole picture rather than one bill at a time.
Access: Durham driveways, Scarborough side yards, and rooftops downtown
Where the equipment sits is the cost factor nobody mentions on the phone. A condenser on a pad beside a detached house in Oshawa or Pickering is the easy case: walk up, open the panel, test.
Scarborough's bungalows and side-splits, and the row houses common in Ajax, tighten that up. A condenser squeezed into a narrow side yard or a fenced gangway takes longer to work on, and if the unit ever needs replacing, the placement question gets solved before anything is ordered.
Condos and apartment buildings are their own category. The equipment cooling a suite is often a fan coil fed from the building's system, a ductless head on the wall, or packaged equipment on the roof, and reaching rooftop equipment means coordinating access with building management. Those calls are closer to our rooftop unit repair work than to a backyard condenser swap, and the labour reflects the logistics, not just the part.
When it breaks matters too
Air conditioners fail when they work hardest, so the busiest weeks for AC repair in the GTA are the hottest ones. During a heat wave, every contractor's board is full, parts counters run thin on common components, and a system limping into July tends to become an emergency instead of an appointment.
The way to stay out of that squeeze is boring: if the AC struggled at the end of last summer, had a top-up, or is past its mid-teens, have it looked at in spring before the first stretch of heat. A shoulder-season repair is the same part and the same labour, booked on your schedule instead of the weather's.
Repair or replace: how we make the call
Most repairs are worth doing. The ones that aren't usually share a few traits, and we'd rather name them than sell a part:
- The failed part is the compressor or a coil, and the unit is well into its second decade.
- The system runs on R-22 and the repair involves refrigerant.
- This is the second or third repair in as many summers.
- The system never cooled the house properly even when it worked, which points to sizing or ductwork, not a part.
- The furnace is also near the end. The indoor coil sits on the furnace, so replacing both together can avoid paying for the same labour twice. Our guide on replacing the furnace and AC together covers that decision.
What a repair visit looks like
A proper repair starts with a diagnosis, not a parts swap. On an air conditioning repair visit we listen to what the system has been doing, check the filter and airflow first, then test the suspect part, electrical values, pressures, and temperatures with the system running where it can run.
Then you get the finding and the repair quoted in writing before any work starts. If the unit is at the point where a repair is money into a system on its way out, the quote says that too, and what a replacement would involve, so the decision is yours with both numbers in front of you. If replacement is where it lands and you're curious about heating with the same equipment, see cold-climate heat pumps.
We repair central air, ductless mini-splits, and rooftop and packaged units across Toronto and the GTA, including Scarborough, Pickering, Ajax, Whitby, and Oshawa. Request a visit with what the system is doing and where the equipment sits, and we'll take it from there.