
Ductless
Ductless Mini-Splitsin Toronto and the GTA
Ductless mini-split installation and repair across Toronto and the GTA. Single-zone and multi-zone systems for houses with radiators and no ducts, hot third floors, additions, basement apartments, and offices.
- Written quote before work
- Residential + commercial
- Toronto and the GTA
Open 24 hours, 7 days a week. Call anytime.
Signs
Signs You Need Mini-Split Repair in Toronto
If two or more of these sound familiar, call before it becomes a no-heat or no-cooling night.
- The third floor or attic room stays hot all summer
- Your house has radiators and no ductwork for central air
- One head blows cold while the others on the system work
- Water drips from the indoor unit onto the wall or floor
- A musty smell when a head starts up
- The outdoor unit hums but the fan does not spin
Timing: Spring is the best time to add a mini-split before the top floor heats up in June. Indoor heads should get their filters and coils cleaned before the humid weeks of July.
Toronto and the GTA
Ductless mini-splits in Toronto homes
A lot of Toronto houses were built before anyone planned for air conditioning. Pre-war semis heated by radiators have no ducts, and third floors, additions, and basements are often left out even in houses that do. A mini-split heat pump runs a small refrigerant line through the wall instead of ductwork, so it fits where central air cannot.
- 01
Radiator houses with no ducts
Many older houses in Riverdale, Leslieville, the Annex, and High Park heat with a boiler and radiators and have nowhere to hide ductwork. A multi-zone mini-split cools the bedrooms and main floor without opening walls and ceilings. You keep the radiators for winter heat, or use the mini-split to take the edge off in spring and fall.
- 02
Third floors, attics, and additions
The top floor of a Toronto semi is usually the hottest room in the house and the farthest from the furnace. A single head sized for that room fixes it without upsizing the whole central system. Additions and converted attics get the same treatment.
- 03
Basement apartments
A basement apartment often needs heating and cooling the upstairs tenant or family does not control. A separate mini-split gives the unit its own thermostat and its own outdoor unit. We size it to the space and place the head where it will not blow straight at the bed or the couch.
- 04
Line sets on brick semis
The refrigerant lines, drain, and wiring pass through one small hole in the wall and run down the outside to the outdoor unit. On brick we plan the route so it follows a corner or downspout and sits under a painted cover. We show you the route before we drill.
- 05
Narrow side yards, flat roofs, and garages
With a shared wall on one side and a tight side yard on the other, the outdoor unit needs clearance for airflow, room above the snow line, and some distance from the neighbour's window. When the side yard will not work, a wall bracket, a flat roof, or a garage roof often will. We also keep the unit's winter defrost water away from walkways, where it can freeze.
- 06
Condo balconies
Some Toronto condos and stacked townhouses allow a mini-split with the outdoor unit on the balcony, and many do not. Work in a condo needs building management approval first, plus set working hours and an elevator booking. Check with your management office before you book, and we will send whatever details they ask for.
Common Ductless Mini-Split Problems We Fix in Toronto
The calls that come in most, and what is usually behind them.
One indoor head not heating or cooling
Likely causes are a refrigerant leak on that head's line, a sensor or board fault, or a blocked filter. We check the refrigerant pressures, the head's sensors, and the airflow before replacing anything.
Water dripping from the indoor unit
Almost always a clogged, kinked, or poorly sloped condensate drain, sometimes a dirty coil. We clear the drain, check its slope to the outside, and clean the coil if it needs it.
Musty or sour smell when a head starts
Dust and moisture build up on the coil and blower wheel inside the head, especially after a humid summer. We take the head apart as far as needed to clean them and clear the drain pan.
Unit not responding to the remote
It can be the remote's batteries, the head's receiver, or a control board. We test the receiver and board and check the power supply before ordering parts.
Ice building up on the outdoor unit
Some frost in winter is normal and clears during defrost. Heavy ice that does not clear points to a defrost control problem, low charge, or a unit sitting where snow and meltwater drip onto it, so we check the controls, the charge, and the placement.
Error code on the indoor unit
Each maker has its own code system, and the same code can have more than one cause. We read the code, then test the actual part it points to before ordering anything.
Repairs, maintenance, and replacement for mini-splits
Mini-split repair
No heat or cooling from one head, error codes, water leaking indoors, or a unit that ignores the remote. We read the fault, check the refrigerant side and the drain, and fix the cause.
Installation
Single-zone and multi-zone systems for semis, bungalows, basement apartments, and home offices. We plan the head locations, the line-set route, and the outdoor unit spot with you before any drilling.
Cleaning and maintenance
Indoor heads collect dust and moisture, and a dirty coil or blower wheel is where the musty smell comes from. We clean the filters, coil, and blower, clear the drain line, and check the outdoor unit.
Zoning and controls
Each head on a multi-zone system runs on its own, so you can cool the bedrooms at night without cooling the empty main floor. We set up the controls to match how you use each room.
Ductless systems we install
Examples of single and multi-zone outdoor units. Indoor heads are matched to each room.
29.9 SEER2
Mitsubishi FX (Hyper-Heat)
M-Series FX · Ductless · Hyper-Heat · ENERGY STAR®
Cold-climate ductless heat pump that holds full heat to -23°C and runs to -30°C, heating and cooling for homes without ducts or for hard-to-heat rooms.
- Cooling
- 29.9 SEER2
- Heating
- 12.4 HSPF2
- Cold-climate
- Heats to -30°C
- Type
- Ductless inverter
Full specs (manufacturer)
- Model
- MUZ-FX12NLHZ + MSZ-FX12NL
- Series
- M-Series FX (Hyper-Heating H2i)
- Cooling efficiency
- 29.9 SEER2 (9k model: 33.1)
- Heating efficiency
- 12.4 HSPF2
- Cold-climate
- 100% heat at -23°C · operates to -30°C
- Type
- Variable-speed inverter (ductless)
- Indoor sound
- 21 – 42 dB(A)
- Refrigerant
- R-454B (low-GWP)
- Capacity
- 12,000 BTU/h · single-zone (multi-zone available)
- Warranty
- 10-year compressor & parts (with registration)
- Certifications
- ENERGY STAR® Certified
ENERGY STAR certified as published by the manufacturer for this model.
Specs as published by each manufacturer. Models shown are examples; the unit we quote depends on the house.
Your options: types, not brands. We match the type to the house, then pick the unit.
Single-zone
One outdoor unit connected to one indoor head. The simplest ductless setup for one room, a converted attic, or a small basement apartment.
Best for: A single addition, top-floor bedroom, or home office
- Simplest setup
- One room
Multi-zone
One outdoor unit connected to two or more indoor heads, each with its own control. It keeps the outside of the house to a single unit, which matters on a narrow lot.
Best for: Radiator houses with no ducts, or several rooms at once
- Several rooms
- One outdoor unit
Cold-climate model
A mini-split heat pump rated to keep producing heat well below freezing. Standard models lose output faster in deep cold, which is when you need the heat most.
Best for: Rooms where the mini-split is the main heat source
- Heats in deep cold
- Cools in summer
How a visit goes
- 01
Tell us what it is doing
Call or send the form. Equipment, what it is doing, and where you are.
- 02
We look at it and give a straight answer
The whole system, including the part that did not fail yet. You get the options in plain words.
- 03
Fix or replace, your call
Written quote first. No work starts until you say so.
Sizing
Ductless Mini-Split Sizing for Toronto Homes
Each indoor head is matched to its own room: the size, the windows, which way it faces, and whether it sits under a hot roof. A head that is too big short-cycles and leaves the room clammy in humid weather. One that is too small loses on the hottest and coldest days. We size room by room, then pick an outdoor unit that can carry all the heads together.
Wall-mount condenserRepair or replace
Repair makes sense when
- One head, one sensor, or one board is the fault
- The system is under 10 years old
- The line set is intact and holding its charge
- The outdoor unit still runs quietly
Replace or add zones when
- The outdoor unit has failed
- You are adding rooms the current outdoor unit cannot carry
- A standard model cannot keep up in a Toronto winter
- Parts for the brand are no longer available
Zoning is decided room by room. We tell you which heads to keep, replace, or add.
What moves the price
Factors, not numbers. We quote after we see it.
Number of zones
More indoor heads means more line sets, more wiring, and more install time.
Length and route of the line set
How far the outdoor unit sits from each head, and whether the lines run straight down a wall or around corners on brick.
Electrical requirements
Some systems need a dedicated circuit, and an older panel may need work to add one.
Head style
Wall, ceiling, or floor-mounted heads install differently, and the choice depends on the room and the furniture.
Outdoor unit placement
Ground stand, wall bracket, flat roof, or garage roof all change the labour and the hardware.
Access and building rules
Third-floor rooms, finished walls, and condo buildings with booking rules take more planning and time.
Written quote after the visit. No work starts until you say so.
Mini-splits: brands we install and service




- Coaire
Ways to pay
Paying for an install
Ask about payment options when we quote the job. The written quote lists the equipment and the work, so you have the full number before you decide.
Ontario rebate, honestly framed
Ontario's Home Renovation Savings program currently covers qualifying heat pumps. Amounts change, and the homeowner claims it through a contractor registered with the program. Ask and we will tell you what applies to your house.
Mini-splits, answered
Can I get air conditioning in a Toronto house with radiators and no ducts?
Yes. A multi-zone mini-split cools several rooms from one outdoor unit without any ductwork. You keep the boiler and radiators for heat, and the mini-split can also heat in spring and fall.
Where does the outdoor unit go on a semi with a narrow side yard?
It needs airflow around it, room above the snow, and some distance from the neighbour's windows. If the side yard is too tight, a wall bracket, flat roof, or garage roof often works. We look at the options on site and tell you which one we would use.
Can I put a mini-split in my condo?
Only if your building allows it. Many Toronto condos control what goes on balconies and walls, and the work needs building management approval, set hours, and an elevator booking. Ask your management office first, and we will provide the details they need to review it.
Do mini-splits work in a Toronto winter?
Depends on the unit. Cold-climate models keep producing heat well below freezing. Standard models lose output faster in deep cold, so they suit cooling and shoulder-season heat better than a room's only heat source.
Are there rebates for mini-splits?
Ontario's Home Renovation Savings program currently covers qualifying heat pumps. Amounts change, and the homeowner claims it through a contractor registered with the program. Ask and we will tell you what applies to your house.
How often should the indoor heads be cleaned?
Rinse or vacuum the filters every few weeks in heavy use. The coil and blower inside the head need a proper cleaning about once a year, or sooner if you notice a smell or weaker airflow.
Mini-splits by area
Related services
Get a written quote for mini-splits
We call you back
At the number you gave us, to ask what the equipment is doing.
We book a window
A day and time that works. Scheduled visits outside the regular route.
Written quote before work
You see the number before anything is replaced. Nothing starts until you say so.