Touchscreen burner control panel with a red switch below it

Commercial boilers

Commercial Boiler Repair in Toronto

A mechanical room usually runs boilers, pumps, and water heaters as one connected system, not separate appliances. We service them together, with the safety lockouts checked along the way.

  • Patterson-Kelley, Lochinvar, Viessmann, Camus, Laars
  • Boilers, pumps, and controls serviced as one system
  • Shutdowns planned with building management

Open 24 hours, 7 days a week. Call anytime.

One system, not separate appliances

In a mechanical room, the boiler doesn't work alone. Pumps circulate the water it heats, controls decide when it fires and how hard, and in many buildings a water heater shares the same room and sometimes the same gas line. We service them as one system rather than treating the boiler as the only thing on the call, because a pump or control fault often looks like a boiler problem from the outside.

We install and service commercial boilers from Patterson-Kelley, Lochinvar, Viessmann, Camus, and Laars.

Low-rise apartments and plazas

A low-rise apartment building often runs one or two boilers in a basement mechanical room that feed every suite, so a fault there reaches the whole building rather than one unit. Plazas and mixed-use buildings tend to run smaller systems, sometimes a boiler for a hydronic loop alongside rooftop units for the storefronts above. Either way, the mechanical room gets checked as part of the building's regular schedule, not only when something has already failed.

Safety lockouts

Commercial boilers have safety controls, low-water cutoffs, high-limit switches, and lockouts, that shut the unit down rather than let it run into a fault condition. When a boiler trips and won't restart, the first step is finding which safety control tripped and why, not resetting it and hoping. A lockout that keeps happening usually points to something upstream: a pump, a control, or water treatment, not the safety switch itself.

Condensing and non-condensing

Boilers in a mechanical room are generally one of two types. Non-condensing boilers run a higher flue temperature and need standard venting. Condensing boilers extract more heat from the exhaust, run cooler flue temperatures, and typically need different venting material and a condensate drain for what they produce. Which type is already installed usually decides what a replacement needs to match, unless the building is planning a bigger mechanical room change.

Shutdowns planned with building management

Boiler work in an occupied building, especially an apartment building where the boiler is the only source of heat, has to be planned rather than dropped on tenants without notice. We coordinate shutdown windows with building management, including how long the building will be without heat or hot water, so residents can be told ahead of time.

What we find on these calls

  • Boiler trips on lockout and won't restart

    A safety control, low-water cutoff or high-limit, shutting the unit down. We find which one tripped and why before resetting anything.

  • Some suites run cold while the boiler is running

    Often a circulating pump or a zone control issue rather than the boiler itself. We check the pumps and controls feeding each zone.

  • Boiler short-cycles

    Can point to a control fault, an oversized boiler for the load, or a water flow problem. We check the controls and flow before assuming the boiler is the issue.

How a visit goes

  1. 01

    Tell us what it is doing

    Call or send the form. Equipment, what it is doing, and where you are.

  2. 02

    We look at it and give a straight answer

    The whole system, including the part that did not fail yet. You get the options in plain words.

  3. 03

    Fix or replace, your call

    Written quote first. No work starts until you say so.

Questions

Do you service boilers you didn't install?

Yes. We work on commercial boilers from Patterson-Kelley, Lochinvar, Viessmann, Camus, and Laars, along with the pumps and controls around them, regardless of who installed the system.

What's the difference between a condensing and non-condensing boiler?

A condensing boiler extracts more heat from the exhaust and runs a cooler flue, which usually means different venting and a condensate drain. A non-condensing boiler runs hotter flue gas with standard venting. What's already installed usually sets what a repair or replacement needs to match.

Our boiler keeps tripping on a lockout. What does that mean?

A lockout is a safety control shutting the boiler down rather than letting it run into a fault. We find which control tripped and why before restarting anything. A repeating lockout usually points to a pump, a control, or water treatment upstream of the boiler itself.

Can boiler work be scheduled without cutting off heat to tenants?

It depends on the system. Buildings with more than one boiler can sometimes keep partial heat during work on one unit. A single-boiler building needs a planned shutdown window, coordinated with building management so residents know ahead of time.

Do you service the water heater in the same mechanical room?

Yes. Water heaters that share a mechanical room with the boiler are checked on the same visit, since they often share gas supply or venting with the boiler system.

Commercial

Related services

Get a written quote for your building

Name and phone are required.

Your service request

We’ll use your details to respond to your request. Privacy policy

  1. We call you back

    At the number you gave us, to ask what the equipment is doing.

  2. We book a window

    A day and time that works. Scheduled visits outside the regular route.

  3. Written quote before work

    You see the number before anything is replaced. Nothing starts until you say so.

CallRequest service