Why we don't publish a price
Two houses on the same street can need very different jobs. One has an open basement, ductwork in good shape, and a clear spot on the side wall for a new vent. The other has the furnace boxed in behind a finished wall, a return duct that was always too small, and nowhere easy for the vent to exit. Same furnace, different amount of work.
So we come out, look at the house, and quote in writing. The quote lists the equipment, the work, and what is included. If you are starting to plan a furnace replacement in Toronto, the sections below are the things that move the price up or down.
What a replacement quote should include
A complete quote covers more than the furnace. These are the pieces we price on a typical replacement:
- The furnace itself, sized to your house.
- Labour to disconnect and remove the old unit and set the new one.
- Venting: new PVC venting for a high-efficiency furnace, or changes to the existing vent.
- Gas line: reconnecting the supply, and re-piping if the connection point moves.
- Ductwork transitions: the plenum and fittings where the new furnace meets your existing ducts. New furnaces are rarely the same shape as the old one.
- A condensate drain, since high-efficiency furnaces produce water that has to go somewhere.
- Any permit or inspection the job needs. That depends on the scope and the municipality.
- Hauling away the old furnace.
- The thermostat: keeping yours if it can run the new furnace properly, or a new one if it can't.
Single-stage, two-stage, or modulating
The type of furnace is one of the bigger price drivers. A single-stage furnace runs at full output whenever it is on, then shuts off. A two-stage furnace runs on a low setting most of the time and steps up to full output in the coldest weather. A modulating furnace adjusts in small steps, so it runs long and low for most of the season.
More stages means more parts and more controls, and the price follows. Whether the upgrade is worth it depends on the house. A smaller home with simple ductwork may not notice much difference past single-stage. A house where the upstairs bedrooms swing hot and cold usually does. We tell you which type we think fits and why, and we can quote more than one if you want to compare.
Sizing comes from a load calculation
An oversized furnace short-cycles: it heats the house in quick bursts, shuts off, and starts again. That wears it out faster and leaves the rooms uneven. An undersized furnace runs constantly and still can't keep up on the coldest days.
The label on your old furnace is only a hint. Many older Toronto houses have had new windows, added insulation, or a finished basement since that furnace went in, so the heat loss today can be different from what it was then. A load calculation on the house gives the actual number. Size affects the price, so a quote built only on the old label can be off in either direction.
Venting: PVC through the wall or the old chimney
Older mid-efficiency furnaces vent up a chimney. High-efficiency furnaces vent through plastic pipe, usually out a side wall or through the roof, and they need a drain for the water they produce. Moving from one to the other is often the biggest single change on the job.
The new vent has to exit where the code allows, clear of windows, doors, and other openings. On semi-detached and row houses with a narrow side yard, finding that spot can take some planning. If a gas water heater shares the chimney with the old furnace, taking the furnace off the chimney can leave the water heater venting into a flue that was sized for both. It may need a liner or its own venting changes. We check for this on the visit so it shows up in the quote before the install starts.
Older houses add work
A lot of Toronto housing stock was built long before today's furnaces. That shows up in a few ways. Basements with low ceilings and narrow stairs make it harder to get equipment in and out. Finished basements often have the furnace closed into a small room, sometimes with drywall that has to come off for access. Ductwork may have been sized for a much older furnace, with returns that are too small for the airflow a new one needs.
None of this rules out a replacement. It changes the labour and sometimes the materials, and it is the main reason a quote from someone who hasn't seen the house is a guess.
A heat pump or hybrid setup instead
If the furnace is due and the central AC is also getting old, it is worth pricing a heat pump before you decide. A heat pump heats in winter and cools in summer. A dual-fuel setup pairs a heat pump with a gas furnace: the heat pump carries most of the season and the furnace takes over in the coldest stretches. Our page on heat pump installation covers the options.
The rebate side is simple. Standard gas furnaces are not covered by Ontario rebates. Ontario's Home Renovation Savings program currently covers qualifying heat pumps. Amounts change, and the homeowner claims it through a contractor registered with the program. Ask and we will tell you what applies to your house.
If you are keeping gas heat and the AC is old, replacing both at once can make sense, since the AC's indoor coil usually sits on the furnace. See central air conditioning replacement for how we size the cooling side.
Paying for it
Ask about payment options when we quote. The written quote lists the furnace and the work, so you have the full number before you decide how to pay.
How to compare two furnace quotes
Quotes for the same house can look far apart until you line them up. Before you compare the totals, check these:
- Same equipment tier. A single-stage quote and a modulating quote are pricing different furnaces.
- Same size, and how each contractor arrived at it. Ask whether a load calculation was done.
- Venting spelled out: new PVC, reuse of the existing vent, and any water heater venting changes.
- Any required permit or inspection listed, so it is not a surprise later.
- Ductwork transitions, the condensate drain, and removal of the old unit named on the quote.
- What happens with the thermostat.
- A written scope. If it isn't written down, it isn't part of the price.
Getting a quote
Send us a note with the age of your furnace if you know it, and a photo of the label if you can get one. We book a visit, look at the furnace, venting, and ductwork, and send the quote in writing. We work across Toronto and the Greater Toronto Area, including Scarborough, North York, Pickering, Ajax, Whitby, and Oshawa. If you aren't sure yet whether the furnace needs replacing at all, read our guide on whether to repair or replace a furnace first.