Cooling guide

AC not cooling? What to check before you call

A handful of checks fix a real share of "AC not cooling" calls on their own. Here's what's safe to check yourself, and where to stop.

Toronto Mechanical Services · Updated September 2026

Furnace not heating or something else wrong? Call and tell us what it is doing.

Call (647) 674-2387

Start with what you can check

Before assuming the AC has failed, a few things are worth checking yourself. None of them require opening the outdoor unit's electrical panel or touching refrigerant lines, and they fix a meaningful share of "not cooling" calls on their own.

Thermostat and power

Confirm the thermostat is actually set to cool, set below room temperature, and has fresh batteries if it uses them. Then check that the furnace switch near the indoor unit, which looks like an ordinary light switch, is on, and that the breaker for both the indoor and outdoor units hasn't tripped. A breaker that trips again after being reset points to an electrical fault and isn't something to keep resetting.

If the house has a smart thermostat installed recently, a wiring mismatch from that install is also worth ruling out, since from the homeowner's side it can look identical to a simple setting problem.

Filter

A clogged furnace filter restricts airflow across the indoor coil, and a coil that isn't getting enough air across it can ice over, which then blocks cooling entirely even though the outdoor unit is running fine. If the filter looks grey, or you can't remember the last time it was changed, that's worth ruling out first. Our furnace page covers how filter type affects how often it needs changing.

Closed or blocked supply vents and return grilles do something similar on a smaller scale, so it's worth a quick walk through the house to check furniture or rugs haven't ended up covering one.

Outdoor unit dirty or blocked

The outdoor condenser has to move air across its coil to reject heat from the house, and it can't do that if it's packed with grass clippings, leaves, cottonwood fluff, or grown in by shrubs. Clear debris away from the unit and give it space on all sides. A unit that's clean and clear but still not cooling points to something beyond what you can see from outside.

A slightly noisy start-up, a brief delay before cold air reaches the vents, or the outdoor unit cycling on and off normally through a hot afternoon are ordinary behaviour, not signs of a fault. What separates a normal cycle from a problem is usually duration and pattern: running constantly without ever satisfying the thermostat, or cycling every few minutes instead of settling into a normal run, both point to something worth checking rather than waiting out.

Ice on the lines means switch it off

If you see ice on the copper line running to the outdoor unit, or frost on the indoor coil if you can see it, turn the system off at the thermostat and let it thaw fully before running it again. Running an iced-up system doesn't help it catch up and can damage the compressor. Once it's thawed and you've checked the filter, try it again. If ice comes back, that's a sign of low refrigerant or restricted airflow that needs a proper diagnosis, not repeated restarts.

Condensate issues

A central AC produces a steady stream of water as it runs, and that water has to drain away through a condensate line and pan. A clogged drain line can back up and trigger a safety float switch that shuts the whole system down, which shows up as an AC that simply won't run rather than one that runs and doesn't cool. Water pooling near the furnace or AC in summer is usually this, and it's worth checking before assuming the compressor has failed.

Where the drain runs, and whether it has a slope the whole way to daylight or a floor drain, affects how often this happens. An older installation with a flatter run can clog more often than a newer one.

When to stop and call

A handful of things aren't safe or sensible to work on yourself, and they're also the ones most likely to be behind a "not cooling" problem that survives a clean filter and a clear outdoor unit. Low refrigerant means there's a leak somewhere in a sealed system, and refrigerant work needs the right equipment and training. A capacitor or contactor that's failed is an electrical component that can hold a charge even with the power off. Anything past a breaker reset is a call, not a DIY project.

  • Ice keeps coming back after the system has thawed and the filter is clean
  • The breaker trips again after being reset
  • The outdoor fan doesn't spin, but the unit hums or clicks
  • Any burning smell, buzzing, or visible damage at the outdoor unit

Getting it looked at

If the checks above don't fix it, request an AC repair visit and describe what you've already tried, including whether it iced up. We test the refrigerant charge, the electrical components, and the airflow before recommending anything, and give you a written diagnosis. See central air conditioning for what a repair visit covers, and if the unit is old and this keeps happening, heat pump installation is worth a look since it replaces the AC and adds heating capacity too.

A lot of "not cooling" calls in the first heat wave of the year are systems that had a small problem sitting unnoticed since last summer, a slow refrigerant leak or a filter nobody thought about over the winter. Running the AC for an hour on a mild spring day, well before the first hot stretch, surfaces most of these while there's still time to book a visit instead of waiting through a heat wave with no cooling.

Questions

My AC has ice on the lines. Is it safe to keep running it?

No. Turn it off at the thermostat and let it thaw fully before running it again. Running an iced-up system doesn't help it catch up and can damage the compressor.

The breaker for my AC keeps tripping. What should I do?

Reset it once. If it trips again, stop and call. A breaker that keeps tripping points to an electrical fault, and repeatedly resetting it isn't a fix.

Why did my AC stop running completely instead of blowing warm air?

A clogged condensate drain line can back up and trigger a safety float switch that shuts the whole system down. Check for water pooling near the furnace or AC before assuming the compressor has failed.

Can a dirty outdoor unit really stop the AC from cooling?

Yes. The outdoor coil has to move air across it to reject heat from the house, and grass clippings, leaves, or overgrown shrubs blocking it can be enough to stop it cooling properly.

Is it safe to clear debris around the outdoor unit myself?

Yes, clearing leaves and clippings away from the unit is safe. Opening the unit's electrical panel, working on the capacitor or contactor, or handling refrigerant is not something to do yourself.

The services

More guides

Get a written quote for air conditioning

Name and phone are required.

Your service request

We’ll use your details to respond to your request. Privacy policy

  1. We call you back

    At the number you gave us, to ask what the equipment is doing.

  2. We book a window

    A day and time that works. Scheduled visits outside the regular route.

  3. Written quote before work

    You see the number before anything is replaced. Nothing starts until you say so.

CallRequest service